Shark Mesh Band is not cuttable, length adjustment can only do on the buckle, therefore a proper “Length range” selection is very important.
This simple tutorial is a measurement guide, two measurements are required:
- your wrist circumference
- watch case size (from spring bar hole to hole)
- Your wrist circumference
You can use a measuring tape or any soft tape eg. USB cable, wrap it around your wrist without slack, to find your wrist circumference in mm.
- Watch case size (from spring bar hole to spring bar hole)
Use a flat ruler to measure the straight distance between spring bars hole to hole in mm.
Click the “Check your size” displayed on every Winghead SHARK Mesh item page, it will redirect you to our “Measurement Guide” page.
Simply enter the above data : Your wrist circumference & Watch case size
Your best match “Length range” result will show up
1. How to measure your wrist circumference
Measure just below the wrist bone (below the wrist bone is the area between your hand and the wrist bone).
Mark the USB cable here.
Note this is your wrist circumference, enter this figure to Winghead Shark Mesh Calculator
2. How to measure your Watch case size
|Click here >>Seiko Watch case size Part 2
Presage Cocktail, Kinetic SUN065, Monster SRP455, Tuna SBBN039, Tuna SBDB009, Baby Tuna SRPA82, SLA017, Atlas SKZ209
|Use a flat ruler to measure the straight distance between spring bar hole to spring bar hole as shown in mm.
Note this is your wrist Watch case size, enter this figure to Winghead Shark Mesh Calculator
Enter the figures in the Measurement Guide Pages , your best match “Length range” result will show up
Just that EASY
Available buckle options :
Head over to our site to see more
Write by Sharon